Removing the iRMC microSD card
Figure 213: Removing the iRMC microSD card
▶
To eject the iRMC microSD card, gently push it in and then let go (1).
▶
Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶
Install the riser module 1, see "Installing a riser module" on page
61.
▶
"Installing the air duct" on page
64.
▶
"Reassembling" on page 52.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 58.
System board and components
308 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
