▶
"Reassembling" on page 52.
▶
"Connecting the power cord" on page
56.
▶
Connect all external cables.
▶
"Switching on the server" on page 58.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server.
●
As soon as the startup screen appears, press the
[F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
"V
erifying the system time settings" on page 82.
▶
"Updating or recovering the BIOS and iRMC S5" on page 69.
▶
If applicable, activate TPM functionality in the system BIOS under
Security > TPM (Security Chip) Setting > Security Chip.
For more information, see the corresponding BIOS Setup Utility Reference
Manual.
▶
"Verifying system information backup or restore" on page 71.
▶
"Looking for MAC/WWN/GUID and SAS addresses" on page 88.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 85.
▶
"Resuming BitLocker functionality" on page 86.
System board and components
RX1330 M4 Upgrade and Maintenance Manual 333
To Next Page
Loading...
