▶
Reconnect all cables to the system board:
– Power cables of PSU
– Front panel cable
– Front USB cable (if applicable)
– Power cable for HDD backplane (if applicable)
– SAT
A cable(s) for HDD backplane (if applicable)
– SATA cable for ODD (if applicable)
– Power cable for ODD (if applicable)
– Front VGA cable (if applicable)
– OOB cable (if applicable)
For the cable plan, see "Appendix B" on page 365.
Concluding steps
▶
If applicable, install the TPM, see "Installing the TPM" on page
296
.
▶
If applicable, install the Dual microSD 64GB Enterprise, see "Removing the
Dual microSD 64GB Enterprise" on page 319.
▶
If applicable, install the M.2 SSDs, see "Installing an M.2 SSD" on page 310.
▶
If applicable, install the iRMC microSD card, see "Installing the iRMC
microSD card" on page 305.
▶
Install the memory modules, see "Installing memory modules" on page 235.
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
▶
Install all fans, see "Installing the new fan module" on page
181.
▶
Install all expansion cards, see "Expansion cards and backup units" on
page 183.
Ensure that you install each card in the slot it was located before the
replacement.
▶
Install the air duct, see "Installing the air duct" on page
64
.
System board and components
332 Upgrade and Maintenance Manual RX1330 M4
To Next Page
Loading...
