Figure 6: Disconnecting the power cords
▶
Disconnect the power cord from the PSU (1).
▶
If applicable, disconnect the power supply of the monitor (2).
4.6
Getting access to the component
4.6.1
Safety notes
CAUTION
▶
Before removing or installing covers (except the bay cover), turn off
the server, all peripheral devices, and any other connected devices,
and unplug all power cables from the outlet. Failure to do so can
cause an electric shock.
▶
In order to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires, the server must
not run while the side cover is removed.
▶
For more information, see
"Important information" on page 25.
Basic hardware procedures
TX1310 M5 Upgrade and Maintenance Manual 43
To Next Page
Loading...
Need help?
General