7.3.2 Removing a 2.5-inch HDD module
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
If the HDD module to be removed is combined into a RAID array, please
proceed as follows:
RAID level
Procedure
RAID 0 Only remove an HDD module combined in a RAID 0 array if
defective.
CAUTION
RAID 0 provides no data redundancy.
In case of an HDD module is defect, all data are lost!
RAID 1 Removing an HDD module from a RAID 1 array will not result in
data loss. However, the removed drive needs to be replaced
immediately by an HDD module of the same or larger capacity
.
After replacing the HDD module, RAID rebuild will be
performed as a background process, see "Performing
a RAID array rebuild" on page 69
.
In order to permanently remove an operational HDD module that is part of a
RAID array from the server, you first need to delete the array using HII
Configuration Utility
.
CAUTION
All data on all HDDs in the array will be lost when deleting the RAID
array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see RAID documentation in "List of
documents" on page 23.
Hard disk drives (HDD)
86 Upgrade and Maintenance Manual TX1310 M5
To Next Page
Loading...
Need help?
General