Figure 25: Connecting the power cords
▶
If applicable, connect the power cord for the monitor to the lower socket (1).
▶
Connect the power cord of the PSU to the upper socket (2).
▶
Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
It will take about 60 seconds until the server can be powered on.
4.9 Switching on the server
CAUTION
▶
Before switching on the server, make sure the side cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
▶
For more information, see "Important information" on page
25
.
▶
Connect all peripheral cables to the server.
Basic hardware procedures
TX1310 M5 Upgrade and Maintenance Manual 57
To Next Page
Loading...
