FUNAI W4D-D4180DB - Recording; Dubbing; One-touch Timer Recording (OTR)

29
Recording / Dubbing
EN
One-touch Timer Recording
(OTR)
This is a simple way to set the recording time in
blocks of 30 minutes. Check that the disc you are
recording onto has enough space remaining for the
time you set.
1 Turn on the unit and insert a
recordable disc.
Make sure that the TV input is set on the unit.
2 Press [DVD ].
3 Select the recording speed using
[REC SPEED].
(See page 23.)
4 Select the desired channel to record
using [PROG. U / D] or
[the Number buttons].
5 Press [REC / OTR] repeatedly until
the desired recording time (30
minutes to 8 hours) appears on the
TV screen.
One-touch Timer Recording will start.
• When the unit reaches the specified time, it will
be turned off automatically.
• To change the recording length during One-
touch Timer Recording, press [REC / OTR]
repeatedly until the desired length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP S].
Hint
• The remaining recording time will appear on the TV
screen during One-touch Timer Recording. Press
[DISPLAY] to see it on the TV screen.
• The remaining recording time will be displayed on
the front panel display during One-touch Timer
Recording.
• Unlike the timer recording, you can perform the
following operations during One-touch Timer
Recording.
- Turn off the power. (One-touch timer recording will
be cancelled.)
-Use [REC / OTR] or [STOP S] on the remote
control.
Note
• You cannot use the pause function during One-
touch Timer Recording.
• The unit will be turned off automatically under the
following conditions.
- No space remains on the disc.
- If a power failure occurs.
• If DVD One-touch Timer Recording is completed
during VCR playback or recording, the DVD will be
in stop mode and the VCR keeps the current mode.
• When One-touch Timer Recording is finished and
the power is turned off, the unit will switch to the
timer-standby mode automatically if a timer
recording has been programmed. Press [T-SET] to
cancel the timer-standby mode to use the unit
continuously.
• If you want to monitor the programme that you are
recording, make sure the device such as a Satellite
Box is powered off or press [DISPLAY] when it is
connected to AV2.
DVD-RWDVD-RW
Video
DVD-RWDVD-RW
VR
DVD-RDVD-R
0:30
8:00 7:30
1:00
Normal
Recording
E9G04ED_EN.book Page 29 Tuesday, March 27, 2007 10:27 AM