Furuno NAVnet TZtouch2 - Default Event Mark Settings; How to Find Number of Points Used

4. POINTS, BOUNDARIES
4-7
4.5.2 Default event mark settings
1. Open the home screen, then tap [Settings] - [Points].
2. Tap [Default Event1 Symbol], [Default Event1 Color], or [Icons Set].
3. Tap required option.
To change the point size, operate the slider bar (or software keyboard) for [Points
Size].
4. Tap the close button to finish.
Note: If you do not require event marks 2 - 6, turn on [Record Event1 Automatically]
in the [Points] menu. In this case, the pop-up menu does not appear when you register
an event mark. See section 4.2.2.
4.6 How to Find Number of Points Used
Open the home screen, then tap
[Settings] - [General]. Find [Points]
in the [DATA USAGE] section. In
the example below, 16 of 30,000
points have been used.
Icons Set
[Default Event1 Symbol]
[Default Event1 Color]
99/100