EasyManua.ls Logo

Furuno NAVnet TZtouch2 - How to Edit a Display Icon

Furuno NAVnet TZtouch2
367 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. SYSTEM INTRODUCTION
1-18
1.8.2 How to edit a display icon
Long tap the display icon to edit to show the editing icons on the display icon. Tap the
applicable editing icon. Refer to the figure and instructions below.
Note: For vessels with more than one TZtouch2 on the same network, changes made
to displays are shared and applied to the other TZtouch2 units.
Edit icon content: Tap the icon at the upper left corner. See the illustration in
subsection 1.8.1 for how to set the icon.
Remove icon: Tap the icon at the upper right corner to remove the icon from the home
screen (and quick page if the icon size is selected to "large".
Change icon size: Tap the icon at the lower right corner to switch the size between
large and small. (Icons set for large size appear on the quick page.)
Long
tap
Remove icon
Change icon size
Edit icon content

Table of Contents

Other manuals for Furuno NAVnet TZtouch2

Related product manuals