Furuno NAVnet TZtouch2 - Speed Alarm

2. PLOTTER
2-15
[Over] or [Under]
The [Over] or [Under] alarm sounds when the temperature is over or under the set
value, respectively.
1) Tap [Temperature Alarm Value] to display the software keyboard.
2) Set the value, then tap []. Go to step 3.
[Within] or [Out of]
The [Within] or [Out of] alarm sounds when the temperature is within or out of the
temperature range set, respectively.
1) Tap [Temp. Alarm Range Min Value] to display the software keyboard.
2) Set the minimum value, then tap [].
3) Tap [Temp. Alarm Range Max Value] to display the software keyboard.
4) Set the minimum value, then tap []. Go to step 3.
[Shear]
The shear alarm sounds when the temperature exceeds the alarm setting for one
minute.
1) Tap [Temp. Shear Alarm Value] to display the software keyboard.
2) Set the value, then tap []. Go to step 3.
3. Tap the close button to finish.
2.10.4 Speed alarm
The speed alarm tells you when the speed of your ship is over or under the limit set.
Set the value at [Speed Alarm Value].
1. Tap [Speed Alarm] on the [Alarm] menu.
2. Tap [Over] or [Under].
3. Tap [Speed Alarm Value] to display the software keyboard.
4. Set the value for [Over] or [Under] then tap [].
5. Tap the close button to finish.