5. ROUTES
5-3
5.2.2 How to create a new route with points
You can create a route with points (including event marks) you have previously en-
tered.
1. Tap a point to display the pop-up menu.
2. Tap [New Route]. The flag mark as below appears on the point. The flag mark ap-
pears on the selected position and the route information box appears (at the top
of the screen).
Note: The route information box is hidden behind the status bar when an alarm
message appears in the status bar.
3. Tap the next route point in the route. A light-blue line with arrow runs between the
previous point and the next route point. The arrow points in the direction of route
flow.
4. Tap the next route point in the route.
Repeat this step to enter all route points. Each route point is numbered.
5. At the last route point, tap [End Route] at the top right-hand corner of the screen
to complete the route.
6. The window for entering route name appears. Enter route name then tap [] to
confirm. The route information box shows, to the last waypoint, the range, time-to-
go, estimated time of arrival and SOG.
Note: The route created above is called an "inactive route". When you create a new
route or tap another inactive route, that route becomes a "sleeping route".
Selected point (starting point)
Selected point (starting point)
Route leg
Drag and drop to change
location of point
Drag and drop to change
location of point
Route information
- RNG: Range between last two points - BRG: Bearing between last two points
- DTA: Distance to Arrival - TTA: Time To Arrival
Inactive route Sleeping route
To Next Page
Loading...
