Furuno NAVnet TZtouch2 - COG Vector Length

2. PLOTTER
2-5
2.5.3 COG vector length
The COG vector shows estimated course and speed of your ship. The tip of the vector
is the estimated position of your ship at the end of the selected predictor time or dis-
tance (set on the menu). You can increase the length of the predictor to find the esti-
mated position of your ship in the future on the current course and speed. You can set
the COG vector as follows. The greater the distance or the time, the longer the COG
vector.
1. Open the home screen, then tap [Settings] - [Ship & Track].
2. Tap [COG Vector].
3. Tap [Distance] or [Time]. For [Distance], do steps 1) and 2) below. For [Time], go
to step 4.
1) Tap [COG Vector Length] to display the software keyboard.
2) Set the length for the COG vector, then tap []. Go to step 5.
4. Tap [COG Vector Time], then tap the time for the COG vector.
5. Tap the close button to finish.