Furuno NAVnet TZtouch2 - Cross Section Display Operations; Availability of Points and Event Marks Registration, and Go to a Point; How to Switch between TX and STBY

8. MULTI BEAM SONAR DFF-3D
8-9
8.4.4 Availability of points and event marks registration, and go to a
point
For how to register points and event marks, see chapter 4.
The table below shows function availability according to latitude/longitude, heading
data presence or absence. If there is no latitude/longitude data, none of the functions
below are available.
For NavNet TZtouch or NavNet TZtouch2, input PGN data. The PGN data available is
as shown below.
Latitude/longitude data
• 129025 Position, Rapid Update
• 129029 GNNS Position Data
Heading data
• 127250 Vessel Heading
• 130577 Direction Data
Latitude/Longitude / Heading data: YES
Latitude/Longitude: YES, Heading data: NO
8.5 Cross Section Display Operations
This section covers the functions available with the cross section display. For the
menu items shared with the conventional fish finder, see chapter 7. To show the menu
for this function, tap the screen to show the pop up menu; or from the [Home] screen,
tap [Settings][Multi-Beam Sonar].
8.5.1 How to switch between TX and STBY
Tap the cross section display to show the pop-up menu. Select [TX] to start transmit-
ting. [ST-BY] appears at the center of the screen when transmission is stopped.
Item Starboard Port
Point registration Yes Yes
Go to point Yes Yes
Event mark registration Yes Yes
Item Starboard Port
Point registration No No
Go to point No No
Event mark registration Yes Yes