4. POINTS, BOUNDARIES
4-13
4.10 How to Move a Point to the Screen Center
You can easily place a point at the center of the plotter display from the points list.
1. Open the home screen, then tap [Lists].
2. Tap [Points] to open the points list.
3. Tap [Name], [Icon], [Color] or [Range] at the top of the list to sort the list.
4. Tap the point to find then tap [Find On Chart].
The menu closes and the selected point is put at the center of the screen on the plotter
display.
Note: If a split screen is in use doing this procedure, the split screen is replaced with
the full screen chart plotter display, then the point is put at the center of the full screen
display.
4.11 How to Show or Hide All Points or Points Names
Points
Open the [Layers] menu, then turn [Points] on or off.
Points names
Open the home screen, then tap [Settings] - [Points]. Turn [Display Points Names] on
or off.
4.12 How to Set Point Density
The screen can become cluttered if all points are shown. To prevent this, set point
density as shown below to limit the number of points to show.
1. On the home screen, tap [Settings][Points][Points Density] to show the follow-
ing options menu.
2. Tap desired point density. [Low] is the lowest point density, and [Full] displays all
points.
3. Tap X on the title bar to close the menu.
To Next Page
Loading...
Need help?
General