Furuno NAVnet TZtouch2 - How to Show or Hide the Scale Box

8. MULTI BEAM SONAR DFF-3D
8-7
From the layers menu
1. Open the layers menu.
2. At [Picture Advance], tap the required speed.
The default speed is [1/1] (normal speed), the fastest speed is [4/1] (four times normal
speed) and the slowest speed is [1/16] (sixteen times slower than normal speed). Se-
lect [Stop] to stop the picture advance for closer examination and screenshots/photos.
8.3.6 How to show or hide the scale box
The scale box, shown at the bottom left corner on the display, shows depth and TX
frequency. You can show the box as follows.
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Scale Box] to show the scale box.
8.3.7 Availability of points and event marks registration, and go to a
point
For operation, see chapter 4.
The table below shows function availability according to latitude/longitude, heading
data presence or absence. If there is no latitude/longitude data, none of the functions
below are available.
For a multi function display, input PGN data. The PGN data available is as shown be-
low.
Latitude/longitude data
• 129025 Position, Rapid Update
• 129029 GNNS Position Data
Heading data
• 127250 Vessel Heading
• 130577 Direction Data
Latitude/Longitude / Heading data: YES
Latitude/Longitude: YES, Heading data: NO
Item Starboard Downward Port
Point registration Yes Yes Yes
Go to point Yes Yes Yes
Event mark registration Yes Yes Yes
Item Starboard Downward Port
Point registration No Yes No
Go to point No Yes No
Event mark registration Yes Yes Yes