*
1
:
Not shown for monitors connected to
HDMI OUT2 port on the TZT2BB.
*
2
:
Requires Remote Controller MCU-004
or MCU-005.
Not shown otherwise.
*
3
:
This menu item does not appear for
TZTL12F/TZTL15F systems.
*
4
: Requires FURUNO BBWX series
Marine Weather Receiver.
Not shown otherwise.
CALIBRATION
Heading
Speed Through Water
Wind Speed
Wind Angle
Sea Surface Temperature
DATA DAMPING
COG & SOG
Heading
Speed Through Water
Wind Speed & Angle
Rate of Turn
FUSION
Connect to Fusion
Fusion Auto Volume
Minimum Speed
Maximum Speed
Volume Increase
BROWSER INSTALLATION
FAX30 Browser
FA30 Browser
FA50 Browser
Chart Master Device*
1
System ID
IP Address
Quick Self Test
Certification Mark
ServiceMan
Event Input Configuration (Off, Event, MOB)
Remote Controller Configuration*
2
Adjust Display Resolution*
3
Update Network Equipments
SIRIUS DIAGNOSTIC*
4
SIrius Radio Diagnostic
Sirius Weather Diagnostic
Track Synchro Enable
Reset Default Settings
2
NETWORK SENSOR SETUP (Shows compatible FURUNO devices.)
To Next Page
Loading...
