23
Active: Put check in check box to make channel active.
Brand*: Enter and display brand name.
Type No.*: Set type no. (equipment name)
Check*: Do equipment check.
Data Name*: Enter data name.
Input Type: Enter input type.
Sampling Data Bit: Displays sampling data bit rate.
Sampling Frequency: Displays Sampling Frequency.
Codec: Sets MIC type
MIC Test Active M1/M3/M5: Put a checkmark when performing MIC Test of M1/M3/M5.
MIS Test Active M2/M4/M6: Put a checkmark when performing MIC Test of M2/M4/M6.
MIC M1/M3/M5 Position: Enter MIC position of MIC M1/M3/M5.
MIC M2/M4/M6 Position: Enter MIC position of MIC M2/M4/M6.
Threshold Level M1/M3/M5: Enter MIC test threshold level of MIC M1/M3/M5.
Threshold Level M2/M4/M6: Enter MIC test threshold level of MIC M2/M4/M6.
Equipment Category*: Set equipment category.
Board Name*: Enter board names where channels are present.
Note*: Enter note.
* Marked Items: For easy identification of input source, enter Equipment Category, Brand,
Type No., Date and Name.
To Next Page
