EasyManuals Logo
Home>FUTABA>Remote Control>T18MZ WC

FUTABA T18MZ WC User Manual

FUTABA T18MZ WC
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
125
Model Menu (Airplane/Glider Functions)
Ɣ(/(WR&DPEHU
This mixing is used when you want to the mix
camber flaps with elevator operation. Lift can be
increased with raised elevators.
[Airplane/glider, 2 ailerons or more]
Ɣ&DPEHU)/3WR(/(
This mixing is used to correct for attitude changes
when the camber Àaps are being used.
[Airplane/glider, 2 ailerons + 1 Àap or more]
Ɣ%XWWHUÀ\&URZ
This function is used when powerful brake
operation is necessary.
[Glider, 2 ailerons or more]
Ɣ7ULP0L[
The ailerons, elevators, and flaps trim offset rate
can be utilized by a switch or condition selection.
[Glider, 2 ailerons or more]
Ɣ$LUEUDNH
This function is used when airbrakes are necessary
when landing or when diving during Àight.
[Airplane, general]
Ɣ*\UR
This is dedicated mixing when a gyro is used.
[Airplane/glider, general]
Ɣ9WDLO
This function adjusts the elevators and rudder of
V-tail models.
[Airplane/glider, V-tail speci¿cations]
Ɣ$LOHYDWRU
This function adjusts the elevators and ailerons of
models with elevator speci¿cations.
[Airplane/glider, elevator speci¿cations]
Ɣ:LQJOHW
This function adjusts the left and right rudders of
winglet models.
[Airplane/glider, winglet speci¿cations]
Ɣ0RWRU
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set.
[EP glider, general]
Ɣ58'WR(/(
This function is used to correct roll maneuvers,
knife edge, etc. of stunt planes.
[Airplane, general]
Ɣ6QDSUROO
This function selects the snap roll switch and
adjusts the steering angle of each rudder. Servo
speed can also be adjusted.
[Airplane general]
Ɣ0XOWL(QJLQH
This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines)
[Airplane, general]
Ɣ$FFHOHUDWLRQ
Acceleration setting can be performed at elevator,
ELE to Camber and AIL to RUD.
[Glider/EP glider]
$,53/$1(*/,'(5
AIR BRAKE
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
V-TAIL
at AILEVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
RUDDER 2
Winglet
RUDDER 1
(ELEVATOR 2)
RUDDER
RUDDER
ELEVATOR
(RUDDER 2)
Winglet
at Flying wing
at Flying wing
at Flying wing
( )
( )
ELEVATOR
(AILERON 5)
ELEVATOR 2
(AILERON 6)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA T18MZ WC and is the answer not in the manual?

FUTABA T18MZ WC Specifications

General IconGeneral
BrandFUTABA
ModelT18MZ WC
CategoryRemote Control
LanguageEnglish

Related product manuals