EasyManua.ls Logo

FUTABA T18MZ WC - Page 5

FUTABA T18MZ WC
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Introduction
$SSOLFDWLRQ([SRUWDQG0RGL¿FDWLRQ
1. This product may be used for model airplane or surface boat car robot use. It is not intended for
use in any application other than the control of models for hobby and recreational purposes. The
product is subject to regulations of the Ministry of Radio/Telecommunications and is restricted
under -apanese laZ to such purposes.
2. Exportation precautions:
a When this product is exported from the country of manufacture its use is to be approved by the
laZs governing the country of destination Zhich govern devices that emit radio freTuencies. If
this product is then re-exported to other countries it may be subject to restrictions on such export.
Prior approval of the appropriate government authorities may be reTuired. If you have purchased
this product from an exporter outside your country and not the authorized Futaba distributor in
your country please contact the seller immediately to determine if such export regulations have
been met.
b Use of this product Zith other than models may be restricted by Export and Trade Control
Regulations and an application for export approval must be submitted. This eTuipment must not
be utilized to operate eTuipment other than radio controlled models.
3. Modification adjustment and replacement of parts: Futaba is not responsible for unauthorized
modi¿cation adjustment and replacement of parts on this product. Any such changes may void the
Zarranty.
Compliance Information Statement (for U.S.A.)
This device trade name Futaba Corporation complies Zith part 15 of the FCC Rules. Operation is
subject to the folloZing three conditions:
1 This device may not cause harmful interference and
2 This device must accept any interference received including interference that may cause undesired
operation.
3 This module meets the reTuirements for a mobile device that may be used at separation distances
of more than 20cm from human body.
To meet the RF exposure reTuirements of the FCC this device shall not be co-located Zith another
transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 1 Apollo 'rive Suite 1 Champaign I/ 1822 U.S.A.
TE/ 217398-8970 or E-mail: support@hobbico.com Support
TE/ 217398-0007 or E-mail: futabaservice@hobbico.com Service
The R%RC. SEA/ on the nickel-cadmium battery contained in Futaba products
indicates that Futaba Corporation of America is voluntarily participating in an
industry-Zide program to collect and recycle these batteries at the end of their
useful lives Zhen taken out of service Zithin the United States. The R%RC.
program provides a convenient alternative to placing used nickel-cadmium
batteries into the trash or municipal Zaste system Zhich is illegal in some areas.
for USA
<ou may contact your local recycling center for information on Zhere to return the spent battery.
Please call 1-800-8BATTERY for information on Ni-Cd battery recycling in your area. Futaba
Corporation involvement in this program is part of its commitment to protecting our environment
and conserving natural resources.
*RBRC is a trademark of the Rechargeable Battery Recycling Corporation.

Table of Contents

Related product manuals