Title Replacing the Heart Rate Monitor Battery
Identifier GUID-2C6A3710-FAD1-4F5A-9FAF-A8C9DD7B8685
Language EN-US
Description
Version 5
Revision 6
Changes Torx T5 screws instead. Ask before using this version. HRM variable too for HRM-Dual bundles.
Status Released
Last Modified 11/09/2020 15:32:54
Author wiederan
Replacing the HRM-Dual Battery
1 Use the included screwdriver (Torx T5) to remove the four screws on the back of the module.
NOTE: HRM-Dual accessories produced before September 2020 use Phillips #00 screws.
2 Remove the cover and battery.
3 Wait 30 seconds.
4 Insert the new battery with the positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.
5 Replace the back cover and the four screws.
NOTE: Do not overtighten.
After you replace the heart rate monitor battery, you may need to pair it with the device again.
122 Device Information
To Next Page