Reference
41
Customizing Track Recording
The Quest automatically records a history of your locations in the Track Log, creating an electronic
“bread crumb” trail of the path you have traveled. This feature can be enabled or disabled from the Track
Setup page (the default is enabled).
Track Recording
– Select Enabled to record tracks or Disabled to stop tracks from being recorded.
Wrap When Full – If set to On, new track points replace the oldest track points once the log is full. If set
to Off, no new tracks are added until the Track log is cleared.
Record Interval – A track point can be recorded based on Distance, Time, or Auto. With Auto, track points
are dropped using a formula and the setting you choose in the Resolution fi eld.
Resolution
– Selects the frequency at which you want track points to be recorded based on how you set
Record Interval (above). Higher resolutions cause the track log to fi ll up more quickly.
Percentage Full
– Shows the percentage of track memory used.
Clear Track – Clears all of the points of the track log from memory.
Note: You can save your track logs to your personal computer. See the MapSource Owner’s Manual for
more information.
If you set the track recording interval to
‘Auto,’ you can choose the frequency at
which the track is recorded.
Customizing Track Setup
190-00323-00_0B.indd 41 8/20/2004, 11:08:35 AM
To Next Page
Loading...
