Appendix
59
Product Safety and Regulatory Information
FCC Compliance
The Quest complies with Part 15 of the FCC interference limits for Class B digital devices FOR HOME
OR OFFICE USE. These limits are designed to provide more reasonable protection against harmful interfer-
ence in a residential installation, and are more stringent than “outdoor” requirements.
Operation of this device is subject to the following conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, you are encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult your Garmin dealer or an experienced radio/TV technician for help.
The Quest does not contain any user-serviceable parts. Repairs should only be made by an authorized
Garmin service center. Unauthorized repairs or modifi cations could result in permanent damage to the
equipment, and void your warranty and your authority to operated this device under Part 15 regulations.
Appendix F: Safety and
Regulatory Information
190-00323-00_0B.indd 59 8/20/2004, 11:08:59 AM
To Next Page
Loading...
