Appendix
50
Data Fields
Speed – The current vehicle speed, displayed in miles or kilometers per hour. (Does not appear on the Trip
Information page.)
Speed-Maximum – The maximum speed recorded since the Trip Computer was last reset.
Speed-Moving Average – Your average speed of travel during the time the vehicle has been in motion since
the Trip Computer was last reset.
Speed-Overall Average
– Your average speed of travel (including time stopped) during the time the Quest
has been tracking your location.
Sunrise
– Time of today’s sunrise at the unit’s present location.
Sunset – Time of today’s sunset at the unit’s present location.
Time of Day – Today’s time.
Time to Destination – Amount of time left until you reach your destination,
Time to Next – Amount of time left until you reach the next turn.
To Course – (Appears only on the Compass page.)
Trip Odometer
– A running total of distance traveled, based upon the distance between second-by-second
location readings, since the Trip Computer was last reset.
Trip Time-Moving
– The length of time that the vehicle has been in motion since the Trip Computer was
last reset.
Trip Time-Stopped – The length of time that the vehicle has been stopped (or stationary) during the time
the Quest has been tracking your location since the Trip Computer was last reset.
Trip Time-Total – The total length of time that the Quest has been tracking your location since the Trip
Computer was last reset. This is always equal to Moving Time plus Stopped Time.
Turn – The angle difference (in degrees) from the bearing to your destination and your current line of
travel. ‘L’ means turn Left, ‘R’ means turn Right. (Appears only on the Compass page.)
Velocity Made Good
– The speed at which you are closing on a destination along a desired course. Also
referred to as the ‘vector velocity’ to your destination. (Appears only on the Compass page.)
Vertical Speed
– Displays the rate of altitude gain/loss over time. (Appears only on the Compass page.)
190-00323-00_0B.indd 50 8/20/2004, 11:08:41 AM