Appendix
53
4. Place the suction cup against the glass and push the
cam lever toward the suction cup (DOWN position) so
that the suction mount is gripped fi rmly against the
windshield. Apply gentle pressure to the suction mount
to make certain the grip is secure.
5. Loosen the adjustment knobs and position the bracket
components once more as necessary to maximize view-
ing.
6. Tighten the adjustment knobs when you are done and
double-check the suction mount's fi rm hold.
7. To remove the suction mount from the windshield, lift
the cam lever (UP position) to release the suction cup's grip. If necessary, pull upwards on the tab on the
bottom of the suction cup to help release the grip.
Connecting the Vehicle Adapter to Your Vehicle
The Quest’s suction mount vehicle adapter includes a 12/24
volt DC adapter with an external speaker system. This is the
Quest’s power and audio source when you are in a vehicle.
Plug the cigarette lighter portion of the vehicle adapter into
an available receptacle in your vehicle. Use care when routing
the cable to ensure that it does not interfere with vehicle opera-
tion in any way.
Increase or decrease the volume by adjusting the volume
control knob on the side of the speaker.
Changing the Fuse
The tip of the suction mount contains an AGC/3AG 1 amp, high-breaking capacity, 1500A-rated fuse.
Periodically, you may need to change it. Simply unscrew and remove the black, round end piece. Remove
the metal tip, and then remove/replace the fuse.
Vehicle Installation
The vehicle adapter comes with an external speaker
system that enables you to hear directions from your
Quest.
Periodically, you may need to change the fuse
that’s located at the tip of the vehicle adapter.
Simply unscrew the black, round end piece and
remove/replace the fuse.
An AGC/3AG 1 amp, HighAn AGC/3AG 1 amp, High
breaking capacity, 1500Abreaking capacity, 1500A
rated fuse is located at therated fuse is located at the
tip of the vehicle adaptertip of the vehicle adapter
Volume control
Speaker
Windshield
Cable and speaker
not shown
Pushing UP on the Cam Lever
releases the suction cup's grip.
Pushing DOWN on the lever
tightens the grip.
190-00323-00_0B.indd 53 8/20/2004, 11:08:50 AM
To Next Page
Loading...
