Gasboy Islander Prime User Manual

MDE-5411A ForeHB Islander Prime Installation Manual · October 2018 Page 91
8.4 Printer Troubleshooting
Fault Probable Cause Checks Corrective Action
No Communication with the Printer
RS-485 cable is
disconnected.
Check the RS-485 cable connections
between the printer and OrPAY1000.
Make correct and
good connection if it
was incorrect.
LAN Cable is
disconnected.
Check the OrPAY1000 LAN cable. Make correct and
good connection if it
was incorrect.
Incorrect Address
settings
Check printer address jumpers (no
jumper means that the address is
70HEX).
Set the correct Hex
address in SiteOmat.
Faulty printer Replace the printer.
Paper is Not Automatically Cut
Paper is not being cut at the
end of the printing.
Incorrect SiteOmat
setting
Check SiteOmat printing settings. Set SiteOmat printing
settings accordingly.
Faulty printer
cutter
Replace printer cutter.
Faulty printer Replace printer.

Gasboy Islander Prime Specifications

General

Brand	Gasboy
Model	Islander Prime
Category	Control Systems
Language	English