Installation 5.7 Islander Prime Setup
Page 68 MDE-5411A ForeHB Islander Prime Installation Manual · October 2018
o Antenna wire:
> 330 feet (100 m) for VIU
> 50 feet (15 m) for Fuel Ring
• Clean dirt and wire remnants
In case problems are detected after installation or during operation, repeat the post-installation
checks listed above.
5.7 Islander Prime Setup
For information on how to set up Islander Prime once installed, refer to the MDE-4817
SiteOmat Installation and Maintenance Manual.
The OrPAY1000 display should not be exposed to direct sunlight. It is therefore
highly recommended to add an awning.
CAUTION
To Next Page
