MDE-5411A ForeHB Islander Prime Installation Manual · October 2018 Page 37
5.1 General Installation
5 – Installation
5.1 General
This section provides the installation procedures for Islander Prime. These procedures include:
• 5.2 Installation Guidelines on page 37
• 5.3 Installing the Pedestal Base on page 38
• 5.4 Installing Options on page 42
• 5.5 Installing Communication Interfaces on page 54
• 5.6 Post-Installation Checklist on page 67
• 5.7 Islander Prime Setup on page 68
5.2 Installation Guidelines
Installation procedures and requirements depend on the specific fuel dispenser models and the
site layout. Therefore, use the information in this section to develop installation plans for each
specific installation. Since installation requirements vary from case to case, no installation
hardware is supplied by the equipment manufacturer, and installation planners must develop
their own requirements.
The customer should provide an installation plan, designed by an a
uthorized engineer. This
plan design should reflect the existing electric infrastructure of the site.
5.2.1 Precautions and Safety Notes
Prior to actual installation activities, carefully observe the precautions and safety notes
detailed in Precautions and Safety Notes and Requirements.
5.2.2 Safety Distances
The following shows the safety distances required for the installation of Islander Prime
adjacent to the dispensers (see Figure 17).
Figure 17: Base Plate Dimensions
To Next Page
