12. AUTOMATION SETUP
12.2 Automation setup for projectors
The SR-1000 supports automation for Barco, Christie and NEC projectors. Follow the steps
below to configure a projector device in the server automation interface.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. On the left column, click Create.
3. Select PROJECTOR as the device type. Enter the name of the projector and click OK.
4. Enter the IP address of the projector device
5. Set the correct model of the projector. The port number will automatically change to the
default automation port number for the model. If the projector is a Series 2 projector,
check the ‘Series 2’ checkbox.
6. Enter Login and Password for the projector, if required.
7. Click Save to save the settings.
To Next Page
Loading...
