12. AUTOMATION SETUP
12.8 Automation setup for USL JSD devices
The SR-1000 supports automation for USL JSD-80 and JSD-100 sound processor. Follow the
steps below to configure a USL JSD device in the server automation interface.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. On the left column, click create.
3. Select USL-JSD as the device type. Enter the name of the USL JSD device, and click
OK.
4. Enter the IP address of the USL JSD device.
5. Select the correct model (JSD-80 or JSD-100) of the device the server is connected to.
6. Click Save to save the settings.
Figure 43: USL JSD device setting
To Next Page
Loading...
