12. AUTOMATION SETUP
12.5 Automation setup for Christie ACT devices
The SR-1000 supports the Christie ACT automation device. Follow the steps below to configure a
Christie ACT device in the server automation interface.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. On the left column, click Create.
3. Select ChristieACT as the device type. Enter the name of the ChristieACT device and
click OK.
4. Enter the IP address of the ChristieACT device.
5. The default setting for Port is displayed on the settings for the ChristieACT device.
Change this value if required.
6. Default control cues will be set up for a new ChristieACT automation device. Control
cues can be added or removed by clicking the + or – buttons.
7. Click Save to save the settings.
Figure 40: Christie device setting
To Next Page
Loading...
