12. AUTOMATION SETUP
12.6 Automation setup for Dolby devices
The SR-1000 supports automation for the Dolby sound processors. Follow the steps below to
configure a Dolby device in the server automation interface. For this example, the device refers to
the Dolby CP650 Sound Processor.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. On the left column, click create.
3. Select DolbyCP650 as the device type. Enter the name of the Dolby CP650 device and
click OK.
4. Enter the IP address of the Dolby CP650 device.
5. Click Save to save the settings.
Figure 41: Dolby device setting
To Next Page
Loading...
