GE ALPS - Memory Map Data Formats

GE Power Management
ALPS Advanced Line Protection System B-15
APPENDIX B B.2 REGISTER MAPS
B
B.2.3 MEMORY MAP DATA FORMATS
Table B–5: DATA FORMATS (Sheet 1 of 12)
TYPE VALUE/
BITMASK
DESCRIPTION
F1 32 bits DATE (32 bits) MM/DD/YYYY
8 bits Month = 1 (Jan), 2 (Feb), etc.
8 bits Day (1 to 31)
16 bits Year 0...80 (2000...2080), 81...99
(1981...1999) or 1981...2080
F2 32 bits TIME HH:MM:SS.sss
8 bits Hours (0 to 23)
8 bits Minutes (0 to 59)
16 bits Seconds (0 = 00.000s, 1 =
00.001s,..., 59999 = 59.999 s)
F3 2 bytes Breaker Indication
0 Open
1Close
F4 2 bytes ON/OFF Indication
0ON
1OFF
F5 2 bytes Reclose State
0 None
1Reclose
2Process
3 Lockout
4 Manual Lockout
5Off
F6 16 bits SYS_960STAT1
bit 0 FLASH self test error in 960 card
bit 1 startup RAM self test error in 960
bit 2 CRC RAM self test error
bit 3 DPRAM self test error
bit 4 Interrupt self-test error
bit 5 Timer self test error
bit 6 EEPROM self test error
bit 7 CAPACITOR RAM self test error
bit 8 RTC failure
bit 9 Watchdo
g
Timer failure
bit 10 N/A
bit 11 N/A
bit 12 Version Error
bit 13 SYSTEM processor in RESET
bit 14 DO h/w disable fla
g
bit 15 N/A
F7 16 bits SYS_960STAT2
bit 0 N/A
bit 1 Di
g
ital output self test error
bit 2 LCD display self test error
bit 3 IRIG-B self test error
bit 4 Rear port 1 present/absent
bit 5 Rear port 2 present/absent
bit 6 Volta
g
e cct # 1 continuity error
bit 7 Volta
g
e cct # 2 continuity error
bit 8 Volta
g
e cct # 3 continuity error
bit 9 Volta
g
e cct # 4 continuity error
bit 10 Volta
g
e cct # 5 continuity error
bit 11 Volta
g
e cct # 6 continuity error
bit 15 Hardware confi
g
uration mismatch
F8 16 bits SYS_ANISTAT
bit 0 A/D controller self test error
bit 1 A/D serial NVM self test error
bit 2 A/D reference self test error
bit 3 Zero crossin
g
self test error
bit 4 A/D ref self test error corrected
bit 5 No ANI/DMA interrupt self test error
bit 6 Di
g
ital Input Error
bit 7 Di
g
ital Input Error Corrects
bit 8 N/A
bit 9 MAG serial NVM self test error
bit 10 Serial Port#1 Error
bit 11 Serial Port#2 Error
bit 12 Serial Port#3 Error
bit 13 Parallel Port Error
bit 15 Power frequency Error
F9 16 bits SYS_DSPSTAT
bit 0 PROM self test error in DSP card
bit 1 startup RAM self test error in DSP
bit 2 CRC RAM self test error in DSP
bit 3 Shared RAM self test error
bit 4 Interrupt self test error
bit 5 Shared RAM checksum error
bits 6 to 12 N/A
bit 13 DSP processor in RESET
bit 14 DSP version error
bit 15 DSP processor in SHUTDOWN
Table B–5: DATA FORMATS (Sheet 2 of 12)
TYPE VALUE/
BITMASK
DESCRIPTION