GE Dash 4000 Service Manual

Troubleshooting: Change internet address
6-12 Dash 3000/4000/5000 2000966-542D
Change internet address
The internet address is an identification number assigned to each device
on the optional CARESCAPE Network. If the internet address has been
corrupted, changing it must be done in Boot Code using a unique
password. Contact your sales/service representative and provide them
with the serial number and internet address of the unit to obtain a
password.
WARNING
Lost Data. Duplication of an internet address on a
network will cause lost data. If you change the factory-
assigned internet address, you must first record all other
internet addresses used on your network to avoid
duplication.
Activate the Boot Loader program as follows:
1. Hold down NBP Go/Stop (or NBP Auto on Dash 5000) and ZERO
ALL (FUNCTION) on the front panel.
2. Press and release the Trim Knob control.
3. Keep holding NBP Go/Stop (or NBP Auto) and ZERO ALL
(FUNCTION) until the Boot Loader information appears on the
display.
4. Select Service Menu > Option Menu > Change Internet Address
to acquire information required for password.

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available