GE Dash 4000 Service Manual

Functional and electrical safety checks: Functional Checkout procedures
8-20 Dash 3000/4000/5000 2000966-542D
Functional Checkout procedures
Frequency
Qualified personnel must perform the checkout procedures:
 Every 12 months after receipt of the device (Preventative
Maintenance). Refer to “Maintenance schedule” on page 5-2 for more
information.
 Each time the main enclosure is disassembled or a circuit board is
removed, tested, or replaced (Corrective Maintenance). Refer to
“Recommended checkout” on page 7-52 for more information.
Identify enabled patient parameters and software options
The check out procedures support all enabled patient parameter and
software options. To view the options enabled on the patient monitor, go
to the Main Menu and select MORE MENUS > MONITOR SETUP >
SOFTWARE CONFIGURATION.
The following is a list of all available patient parameter and software
options.
 0BP (invasive)
 1BP or 2BP (invasive)
 3BP or 4BP (invasive)
 12SL
 ACI-TIPI
 HI-RES TRENDS
 ETCO
2
(CO
2
) (End-tidal CO
2
)
 NETWORK
 AVOA Plus
 CARDIO-PULMONARY
 CARDIAC

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available