GE Dash 4000 Service Manual

Field replaceable units: Replace display assembly parts
2000966-542D Dash 3000/4000/5000 7-31
Replace display components without LCD
NOTE
These instructions are to replace the display components, not the
LCD. If the LCD fails, order the Display Assembly field replaceable
unit.
7. Secure the new keypad with the screws. 7. Reattach the keypad cable. 6. Secure the new keypad with the screws.
8. Make sure the washer tab fits in the
retaining slot of the Trim Knob control’s
shaft and re-install the 11mm nut.
8. Secure the new keypad with the screws. 7. Secure the Trim Knob and reassemble
the display assembly in reverse order.
9. Secure the Trim Knob by reassembling
the display assembly in reverse order.
9. Make sure the washer tab fits in the
retaining slot of the Trim Knob control’s
shaft and re-install the 11mm nut.
8. Complete the procedures in
“Recommended checkout” on page 7-
52.
10. Complete the procedures in
“Recommended checkout” on page 7-
52.
10. Secure the Trim Knob and reassemble
the display assembly in reverse order.
11. Complete the procedures in
“Recommended checkout” on page 7-
52.
Dash 3000 patient monitor
with display shield flex circuit
Dash 4000 patient monitor Dash 5000 patient monitor

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available