GE Dash 4000 Service Manual

Configuration: Boot Code settings
4-22 Dash 3000/4000/5000 2000966-542D
1. Activate Boot Code (“Boot Code settings” on page 4-18) and select
SET CONFIGURATION menu option.
2. Select the IntelliRate menu option.
3. Select enabled to activate this option, or disabled to deactivate this
option.
4. Select Exit and wait for the patient monitor to display the message,
“Writing settings to Flash config mem...”
5. Manually reboot the patient monitor to implement this change.
6. Refer to the operator’s manual to configure the patient monitor to
use this feature.
Analog Out Buzz
Select Analog Out Buzz to identify an ECG or an invasive BP “leads off”
condition via a supported analog out device. The default is 0 volts.
1. Activate Boot Code (“Boot Code settings” on page 4-18) and select
SET CONFIGURATION menu option.
2. Select the Analog Out Buzz menu option.
3. Select 60Hz sine wave to display a 60 Hz sine wave, or select 0 volts
to display a flat line.
4. Select Exit and wait for the patient monitor to display the message,
“Writing settings to Flash config mem...”
5. Manually reboot the patient monitor to implement this change.
Completion
The patient monitor is now ready for normal operation. At this time,
perform procedures in “Functional and electrical safety checks” on
page 8-1.

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available