GE Dash 4000 Service Manual

Configuration: Procedures
2000966-542D Dash 3000/4000/5000 4-9
Procedures
Listed below are the patient monitor settings that can be configured.
Each procedure is described on the next pages.
From the Main Menu
 “Set print locations” on page 4-10
From Service Mode
 “Set Unit Name” on page 4-11
 “Set Bed Number” on page 4-11
 “Patient-Monitor Type” on page 4-12
 “Admit Menu” on page 4-13
 “Confirm or configure wireless LAN” on page 4-14
From Boot Code
 “Set Defib Sync Voltage and pulse width” on page 4-18
 “Set Line Frequency” on page 4-18
 “Set CIC and QS protocol” on page 4-19
 “Set MUSE system protocol” on page 4-19
 “Transcutaneous Pace Blank Length” on page 4-19
 “Set Country Selection” on page 4-20
 “Set Language” on page 4-20
 “Enable or disable AFIB Identification” on page 4-21
 “Enable or disable IntelliRate” on page 4-21
 “Analog Out Buzz” on page 4-22
Also see “Advanced user procedures” on page 4-23 to
 “Set time and date” on page 4-23
 “Transfer monitor defaults” on page 4-24
After completing all necessary procedures, go to “Functional and
electrical safety checks” on page 8-1.

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available