GE Dash 4000 Service Manual

Functional and electrical safety checks: Electrical safety tests
2000966-542D Dash 3000/4000/5000 8-11
13. Read and record the current leakage indicated on the tester.
14. Set the power switch of the device under test to OFF.
If measured reading is greater than the appropriate specification below,
the device under test fails. Contact GE Technical Support.
Acceptance criteria NC
 100 microamperes (0.1 volts on the tester), and the device under
test is powered from 100-240 V/50-60 Hz
Acceptance criteria SFC – ground (earth), line or neutral open
 (USA only) 300 µA, and the device under test is powered from
100-120 V/50-60 Hz
 (USA only) 300 µA, and the device under test is powered from a
center-tapped 200-240 V/50-60 Hz, single phase circuit (UL Split
Phase Exemption)
 500 µA, and the device under test is powered from a non-center-
tapped, 200-240 V/50-60 Hz, single-phase circuit
NOTE
If the reading is greater than the specification below, and the
device under test is powered from 100-240 V/50-60 Hz, the device
under test fails. Contact GE Technical Support.

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available