GE Invenia ABUS 2.0

Invenia ABUS 2.0 – System Setup and Basic Service Manual Index-3
4700-0043-00 Rev. 4
P
packing materials
recycling information, 3-33
paperwork
after setup, 3-71
parts
renewal, 9-1
parts disposal, 8-5
patient vicinity UL60601-1 (USA), 2-19
Performance functional checks
power on, 4-12
performance functional checks
3D volume, 4-13, 8-11
B-Mode, 4-13, 8-11
exam, 4-13, 8-12
probe, 4-12, 8-11
shut down, 4-12
phone numbers
customer assistance, 1-25
physical inspection
at arrival, 3-34
power on, 3-45, 4-4, 4-5
power on scan station, 3-46
power on/boot up, 4-4
connect power to the product, 4-5
warnings, 4-3
power shut down, 3-45, 4-6
precautions
certified electrical contractor statement, i-15
damage in transport, i-15
for functional checks, 4-2
important precautions, i-2
service safety considerations, i-17
translation policy, i-2
prepeare for setup, 3-34
probe, 4-12
functional check, 4-12, 8-11
product icons, 1-11
product locator installation card, 3-72
products covered by this manual, 1-3
purchaser responsibilities, 2-7
purpose of operator manual, 1-3
R
rear panel
connections, 3-42
receiving and unpacking, 3-4
receiving the product, 3-5
recycling information
packing materials, 3-33
renewal parts, 9-1
abbreviations, 9-2
replacement
covers, 8-15
service table, 8-15
replacement procedures, 8-1
warnings, 8-2
requirements, 2-2
returning/shipping probes and repair parts, 1-27, 8-4
revision history, i-1
S
safety, 1-18
electrical
practices, 1-17
transducer, 1-17
human, 1-13
safety considerations, 1-13
safety precaution messages, 1-9
scan station
specifications, 2-11
scan station and workstation
overview, 1-4
scan station date, 3-49
scan station power on, 3-46
scan station setup, 3-46
scan station time, 3-49
self generated noise, 7-35
service adjustments, 6-1
service login, 3-46
service manual, 4-11
service safety considerations, i-17
service table replacement, 8-15
setting up time and date, 3-49
setup
preparations, 3-34
reminders, 3-2
scan station, 3-46
setup time, 3-2
setup warnings, 3-2, 3-40
shipping/returning probes and repair parts, 1-27
probe
returning/shipping, 8-4
shut down, 4-12
site preparations, 2-1
time and manpower requirements, 2-8
software load, 8-14
software problems, 7-36
specifications
electrical specifications, 3-41
scan station, 2-11
standard hazard icons, 1-10
statement
certified electrical contractor statement, i-15
system
electrical configurations, 2-9
system manufacturer, 1-26
T
time and manpower requirements
site preparations, 2-8
time format, 3-63