GE LPS-O - Page 190

8-
22
LPS-O Line Protection System GE Power Management
8.2 INFORMATION 8 LOCAL USER INTERFACE
8
• Fail: Trip circuit continuity monitor #3
• Fail: Trip circuit continuity monitor #4
• Fail: Trip circuit continuity monitor #5
• Fail: Trip circuit continuity monitor #6
• Fail: Software version error
• Fail: DSP software version error
• Fail: More than 4 warm restarts occurred in an hour
• Fail: i960 DSP interface
• Fail: Runtime flash test CRC check
• i960 Instruction fault
• i960 Arithmetic fault
• Too many bogus interrupts
• Warning: CPU board timer test
• Warning: Zero crossing logic
• Warning: CAPRAM failure
• Warning: RTC test failure
• Warning: Comm front port failure
• Warning: Comm rear port 1 failure
• Warning: Comm rear port 2 failure
• Warning: Watch dog timer failure
• Warning: LCD display failure
• Warning: IRIGB failure
• Warning: Rear port 2 absent
• Warning: Non critical field in model number
• Warning: CAPRAM size mismatch
• Warning: Frequency error
•Warm restart
• ANI reference corrected
• Digital input error corrected
• MAG module error corrected
• ANI module error corrected
• LCD display error corrected
• Remote communication login failure
• Passwords changed
• Outputs enabled
• Outputs disabled
• Manual trip
• Manual close
• Manual trip failed
• Manual close failed
• Setting changes started
• Setting changes completed
•Protection OFF
•Protection ON
• Fault queue in CAPRAM re-initialized
• Event queue in CAPRAM re-initialized
• OST oscillography data area re-initialized
• Equipment duty is reset
• Active setting group changed
• Protection re-initialized
• Request for protection re-initialization not serviced
• Factory settings done
• Error in constants used by protection
• Error in code area of configurable logic
• LPS Initialized
• Trip signals ON
• Trip signals reset
• Trip A signal ON
• Trip A signal reset
• Trip B signal ON
• Trip B signal reset
• Trip C signal ON
• Trip C signal reset
• Out of step block ON
• Out of step block OFF
• Breaker #1 open
• Breaker #1 closed
• Breaker #2 open
• Breaker #2 closed
• Fuse failure alarm ON
• Fuse failure alarm OFF
• Key transmitter ON