GE LPS-O - ALPS-TEST SOFTWARE; INTRODUCTION; Description; Starting for the First Time

GE Power Management LPS-O Line Protection System 10-
1
10 ALPS-TEST PROGRAM 10.1 INTRODUCTION
10
10 ALPS-TEST PROGRAM 10.1 INTRODUCTION 10.1.1 DESCRIPTION
The ALPS-Test program is designed to be used with both the ALPS and LPS series of relays. ALPS-Test is
used to generate test data for the measuring units in the LPS-O relay for the settings specified by the user.
This data can be used to validate your test data.
In order to run the program, the following files need to be installed in a directory of the tester’s choice.
ALPS_TST.EXE
ALPS_TST.INI
ALPS_TST.HLP
PUSHHELP.VBX
10.1.2 STARTING THE PROGRAM FOR THE FIRST TIME
Install the program from the GE Power Management Products CD or from the GE Power Management Web
site at www.ge.com/indsys/pm. See Section 11.2.4: SOFTWARE INSTALLATION on page 11–4 for instruction
on installing the LPS-O software suite. This installation procedure will install ALPS-Test along with the LPSO-
Link and Xpression Builder software packages.
When the program is started, the following screen is displayed.
Figure 10–1: ALPS-TEST INITIAL SCREEN