GE LPS-O - Page 223

GE Power Management LPS-O Line Protection System 10-
15
10 ALPS-TEST PROGRAM 10.6 TOOLS MENU
10
• The focus is set to the first item in the
Menu contents
list box.
• The menu text is in the
Menu text
box.
• The
Command line
text box has the invalid path name.
Change the path name to the correct path. Click on the
OK
button. Pull down the
Tools
menu and click on the
tool.
• Verify that the program started.
Select the
Setup
menu item again. Add a second tool.
• Verify that the tool gets added after the first tool.
Click on the
OK
button. Pull down the
Tools
menu.
Verify the following:
• There are two tools and they are in the correct order.
• The two tools are followed by a separator bar and the
Setup
menu item.
Select the
Setup
menu item again. Leave the first item in the
Menu contents
list box selected. Add a third
tool.
Verify that the tool gets added after the first tool and before the second tool.
Click on the
OK
button. Pull down the
Tools
menu.
• There are three tools and they are in the correct order.
• The three tools are followed by a separator bar and the
Setup
menu item.
To Remove a tool, select the
Setup
menu item again. Select the second item in the
Menu contents
list box.
Click on the
Remove
button.
• Verify that the selected item gets removed from the
Menu contents
list box and that the item immediately
below the one removed is selected.
Click on the
OK
button. Pull down the
Tools
menu.
• Verify that there are two tools and they are in the correct order.
• The two tools are followed by a separator bar and the
Setup
menu item.