D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-23
PRELIMINARY
4-3-9 Peripheral Checks
4-3-9-1 Printer Checks
The internal printer is controlled from the Print button on the Venue™ ’s application main screen.
Table 4-20 outlines the steps for performing Printer checks.
4-3-9-2 Windows Print Test Page
This checks that the printer is correctly installed and hooked up at the Windows level.
1) On the Venue™ application main screen, tap: Settings > Config > Connectivity > Additional
Outputs.
Figure 4-12 In the Printer Setup section, verify that the selected printer is Sony UP-D711MD.Verifying Selected
Printer
Table 4-20 Printer Checks
Step Task Expected Result(s)
1
When scanning in 2D Color
Mode, press Freeze to stop
image acquisition.
Image scanning stops with the last
picture on the screen.
2
Press the Print button The image displayed on the screen is
printed on the assigned printer.
3
Check if the print quality on the
pictures from both printers are of
expected quality.
To Next Page
Loading...
