8-22 Section 8-3 - Covers - Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-3-11-5 Riser Cover Installation Procedure
1.) Install the rubber cap on the riser cover.
2.) Install four rubber cable guides (two short guides on the back side and two long guides in the front
side) on the riser cover. Use a flat screwdriver to gently affix the rubber guide in place, if required
3.) Install new riser cover on riser and secure the four securing screws
Figure 8-13 Installing Riser Cover Rubber Cap
Short rubber guide
Figure 8-14 Installing Rubber Cable Guides
To Next Page
Loading...
