GE Venue R2

8-84 Section 8-6 - Mechanical Parts- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
6.) Remove the Halo Handle mounting screws: four (x4) front screws and four (x4) side screws (two
from each side).
7.) Lift the handle upwards and remove it.
Figure 8-66 Removing the Halo Handle - Mounting Screws
Figure 8-67 Removing the Halo Handle
Halo Handle Side Screws
Halo Handle Front Screws
Lift and Remove the Halo Handle
Halo Handle Removed