8-118 Section 8-6 - Mechanical Parts- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
5.) Reattach ferrite to the MPB to Cockpit cable, approximately 3 cm below the cable connector.
6.) Connect the MPB to Cockpit cable to the cockpit, and fasten the flat screws.
7.) Reconnect the ground cable.
8.) Make sure the MPB to Cockpit cable is routed under the pin that is located on the rear side of the
Figure 8-107 Attaching Ferrite to MPB to Cockpit Cable
Figure 8-108 Connecting the MPB to Cockpit Cable to Cockpit
To Next Page
Loading...
