Chapter 8 - Replacement Procedures 8-131
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
• Three in the front end
• One between the connectors and the MPB receptacle side.
12.)Close the cable cover door:
• Slide the cable cover door towards the system, and fix the rubber grommet in its position
• Close the captive screw of the cable cover door using a Phillips screwdriver.
13.)Install the arm side cover.
14.)Secure side cover with two securing screws.
15.)Install the arm base cover.
16.)Refit the following covers: Left Side eTower, Riser Thermal, Right Side eTower, Lower Front
Figure 8-132 Plastic Clips Holding the Cable
Figure 8-133 Closing Cable Cover Door
To Next Page
Loading...
