Chapter 8 - Replacement Procedures 8-151
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
• Display port
8.) Remove the PCB:
• Release four screws in the PCB corners using Phillips screwdriver
Note: If the MiTx to BIB cable is preventing easy removal of the PCB, disconnect the MiTx to BIB
cable connector latch (see yellow circle in the above figure).
• Gently take out the PCB.
9.) The cables are now exposed and easy to access. Disconnect the relevant cable that is being
replaced:
• USB split cable (use socket wrench 5.5mm)
• HDMI cable (use socket wrench 5.5mm)
• Network cable (use socket wrench 5.5mm)
Figure 8-154 Disconnect BE Cables from BE Back
Figure 8-155 Remove PCB
To Next Page
Loading...
