8-158 Section 8-6 - Mechanical Parts- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
3.) Disconnect the MPB TO T-FEPS cable edge
4.) Disconnect the two lower cable connectors by sliding them upwards
5.) The cable is released.
8-7-11-5 MPB TO T-FEPS Cable Installation Procedure
1.) Connect the two lower cable connectors by sliding them downwards
2.) Connect the MPB TO T-FEPS cable edge
3.) Connect the following cables to BE module:
• MPB to BIB
• MPB to BEP (white)
• Cockpit to BEP split cable (green and black)
• Printer cable (yellow)
4.) Install the MPB module.
5) Install the MPB Front Metal Door.
6.) Install the following covers: Lower Front eTower, Left side eTower, Right Side eTower and RS
Probe cover.
Figure 8-165 Disconnecting MPB to T-FEPS Cable Edge
• MPB Module Installation Procedure
• MPB Front Metal Door Installation Procedure
• Left Side eTower Cover Installation Procedure
• Right Side eTower Cover Installation Procedure
• Lower Front eTower Cover Installation Procedure
To Next Page
Loading...
