8-192 Section 8-9 - Operating System and Application Software Loading Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
16.)The settings screen appears. The Local tab opens by default.
17.)Continue with the EZ Config installation as specified in Section 3-6-2-1 on page 3-27.
8-9-2-1 Reformatting Disk-on-Key
The purpose of this procedure is to allow the user to format the disk-on-key and to regain the initial
storage capacity of the media used for burning software downloaded from GE portal.
1.) On your PC, insert the Disk-on-Key media into any available USB port.
2.) Browse to the folder that contains the files downloaded from GE portal.
3.) Run the RevertFlashDisk.cmd command.
NOTE: If the Windows Protected Your PC window pops up, click More Info and then click Run Anyway.
If prompted to allow apps to make changes to device, click Yes.
4.) Wait until the formatting is complete. The process may take about 3 minutes.
Perform the checks listed in Operating System and Application Software Installation Procedure on
page 8-219
To Next Page
Loading...
